Tag: nail knives, nail dies, rolling wheels, feeders, wire drawing dies
The automatic nailing machine greatly improves the production efficiency of the nail making operation in the nail making factory, but the equipment problem of the developing machine also comes along. What is the working principle of a nail making machine? The work efficiency is not high? These problems directly affect the performance of the nail making machine, the cost and profit of the nail.
UKO-”ten-year-old driver “specializing in the production of various wire tools and nail-making accessories. Founded in 2009 in China's largest cemented carbide production area - Zhuzhou, and began exporting to Southeast Asia, Europe, Africa and other major foreign markets in 2011. Based on long-term cooperation experience with various famous brands, such as MORONI, VITARI, KOVOPOL, WAFIOS, etc., UKO easily solves the problem of machine failure as follows:
Three major faults and troubleshooting methods for the top part of the automatic nailing machine
1) Top opening: The reason may be that the nail ash or the nail hardness is too high, it is necessary to change the nail or temper, or the nail knife may not be ground, and the nail knife needs to be calibrated according to the regulations.
2) Nail: There are three reasons for this failure. First, the nail blade is not straight, and the nail knife is sharpened. Secondly, the hardness of the nail blade is too low, and the hardness of the nail knife needs to be improved. Third, the nails are soft and hard, and the nails need to be replaced.
3) The top is not correct: First of all, the size of the nail knife edge is inconsistent, which is necessary to re-sharp the nail knife. In another case, the position of the cutting edge is wrong, just re-adjust the position of the nail knife.
How to solve the four problems of nail making machine nail cap?
1) No nail cap: This is a common fault. A large part is a reason why the clip is not tight. Just replace the fixture. There is another reason why the nail of the nail cap is reserved. Too short, adjust the length of the reserved nail wire.
2) Nail cap is not round: This problem is usually also on the fixture. Firstly, observe whether the countersunk hole on the fixture is round. If it is not round, it needs to be re-drilled. It is also necessary to observe whether the die hole is uneven or not. smooth. Another possibility may be the problem of nailing or the nail thread reserved for the nail cap is too short, and the length of the reserved nail wire needs to be adjusted, or the nail wire is too hard to punch out the nail cap. Then the nail wire needs to be annealed.
3)Nail cap thickness: also need to check the fixture, see if the height of the two clamps is the same,but also whether the fixture can clamp the nail, then to observe whether the counterbore of the fixture has single-sided wear In the end, it is necessary to observe whether the nail is too hard and the nail cap that is flushed out is unqualified.
4) Nail cap skew: First, see if the center of the two nail knives is consistent with the center of the nail mold, whether the front and rear heights of the nail knives are neat, and whether the countersink positions of the two nail dies are in the same plane or the shell is loose.
UKO specializes in the production of nail knives, nail dies, rolling wheels, feeders, wire drawing dies, punches (can be engraved) and other tools to provide accessories for various nail making machines. We have complete and efficient supply, QC, warehousing, packaging, shipping inspection, after-sales service system, if you have any nail machine or accessories problem, please leave a message!
Welcome to the website: www.ukocarbide.com www.ukowiretools.com
Edited by: Sophie Chou
No comments:
Post a Comment